notice de pose et entretien des insert de cadre moto

INSTALLATION GUIDE

Engraved motorcycle frame inserts

1. Surface preparation

Proper surface preparation is essential:

  • Clean the area with a 50% water / 50% isopropyl alcohol mixture.

  • Wipe with a slightly damp cloth (not soaked) to remove any residue.

  • Dry immediately with a clean, dry cloth.

👉 The surface must be perfectly clean, dry, and grease-free.

2. Positioning the insert

  • Place the insert in its location to check alignment.

  • Remove the red protective film from the adhesive.

  • Position the plate at an angle of approximately 45° relative to the frame surface.

    • This prevents the entire adhesive surface from sticking instantly.

  • Adjust the alignment precisely.

  • Bring the plate into contact without pressing, simply set it in place.

  • Make final alignment adjustments.

3. Final bonding

Once the position is perfectly set:

  • Press firmly on the plate.

  • Apply pressure:

    • around the entire edge,

    • then on the center,

    • repeating several times across different areas.

  • Maintain firm pressure for 1 to 2 minutes.

  • full cure after 24 hours 

👉 This step is essential: it activates the adhesive and ensures optimal bonding.

Optional recommendation

  • You may add a small amount of Sika 11 FC adhesive if you want extra security.

  • The supplied double-sided adhesive is professional grade and, when properly applied, can replace rivets and screws.

Technical data sheet:
https://multimedia.3m.com/mws/media/1535287O/vhb-tape-5962.pdf

Installation video:
https://www.youtube.com/watch?v=LNCY7bfmFik

and a video showing how to fit the inserts :

https://www.youtube.com/watch?v=3JBd9vOBLYs&t=18s

MAINTENANCE GUIDE

Engraved motorcycle frame inserts

1. Aluminum inserts

  • Clean using a Belgom Alu-type wipe.

  • Wipe with a clean, dry cloth.

👉 Quick and easy maintenance.

2. Brass inserts

Brass is a living material that evolves over time.

Option 1 – Natural patina

  • Let the brass patinate naturally.
    👉 Darker, vintage appearance.

Option 2 – Patina + light maintenance

  • Let it patinate.

  • Occasionally rub with a cotton cloth (old sheet type).

👉 Important:

  • Keep this cloth.

  • The darker it becomes, the more effective it is.

Option 3 – Polished finish

  • Use a Mirror-type wipe (brass/copper).

  • Buff with a cotton cloth to restore shine.

👉 Restores a bright, like-new finish.

⚠️ Important

  • Do not use liquid products (Belgom liquid, Mirror liquid, etc.).
    👉 They may fill the engravings and damage the final appearance.